What made it particularly interesting was that part of the way through Isaac ran out of some small but essential pieces and had to work out how to free them from where they were in the track so that he could use them else where.
These first three pictures show the initial stages of the layout. First, what will become the centre track is laid. The lift bridge and engine shed are good points of reference for later photos. The second photo shows this track has a Y junction at the other end which leads round to the turntable. In photo three the track is extended right the way back down to cross over the lift bridge.

Isaac then found he needed another double ended piece to complete the main loop. After a little while he figured out he could free both of the pieces by turning the turn table round by 90 degrees. It did mean having to redo the loop which went under the bridges. If you look carefully at the two similar photos to the right you can see the changes that were made. The loop joining the lifting bridge and the other end of the Y junction was completed, including the doubled ended piece.

The final elements was a passing loop that was added to the last straight and a short curving siding. It needs top be noted that Isaac's brother was definitely a co-creator of this layout and the boys cooperated beautifully to create a really pleasing layout.
Tracing my fingers round the track, as I do, I could see it had lots of possibilities in terms of routes and direction and it kept the boys busy for a long tie as they explored the options.
No comments:
Post a Comment